diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Pioneer sx 535 receiver (http://www.diyaudio.com/forums/solid-state/9640-pioneer-sx-535-receiver.html)

oldmarantz 8th January 2003 08:30 PM

Pioneer sx 535 receiver
 
I picked up an old pioneer sx 535 this afternoon And got one pb with it.
when you switch off the receiver there is a scratch for 10 seconds in the left channel.I look at the offset and when I measure the left channel with a multimeter there is at least between 30 to 38 mV and the right channel is stable at 10 mV...pb with a cap? but where?is someone has got the schems of this receiver or a clue to repair it easily...

thanks for your help

Dom.

EchoWars 8th January 2003 09:48 PM

Feedback should take care of the offset unless there is a ground problem or a bad transistor. I doubt that this amp uses an output coupling cap...probable causes are a faulty ground connection at the preamp or amp board, or a flaky transistor in a LTP at the amp input...in which you simply replace the pair.

oldmarantz 9th January 2003 05:46 PM

Hi all
I took a look at the amp board this afternoon... don t find something wrong I checked caps Trs but all seems good (it s a little hard without schems :xeye: ) power supply seems good (checked with scope)I ll try to change the PP to see... it s a 2 SA489 2 SC789.
have you got the equivalent tr for 2sa489 (to220 pnp 60v 4a)this tr is Discontinued..

thanks for your help...

Dom.

EchoWars 9th January 2003 08:28 PM

Sounds like you are looking at the output transistors...the feedback is taken from the output and fed back to the input, which is where the correction for DC offset should occur. The input of the amp section is where you will want to look to cure the offset.

Track down a schematic wherever you can. It's worth paying for, and the 535 is a pretty decent sounding receiver once you get it cleaned up, just not very high power.

If you actually found a bad 2SA489, a 2SB858 would work well here. But don't start replacing output transistors to fix DC offset, you will be wasting your time.

oldmarantz 10th January 2003 04:00 PM

OK Thanks for your help I ll try to find a schems because without it s not easy and look at the input of the amp...tell you if I find something wrong...

Dom.

oldmarantz 12th January 2003 10:09 AM

For info...it was just a solder problem after I did again solder on the power board the problem is gone...:)

Thanks for your help

Dom.

EchoWars 12th January 2003 10:18 AM

Good Job!! :D


All times are GMT. The time now is 07:04 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2