Post your Solid State pics here.

[Bee C.]

Hmm I tried to finishing thiss amp....

[Jan Dupont]

My new LYNX v3.0

[Jan Dupont]

Close up

[Jan Dupont]

EDIT: There seems to be happening strange things in here at the moment Post was rejected, but was online anyway...
I think Cyber has it's own life

[fotios]

Originally posted by ACD
My new LYNX v3.0

Hi colleague Jan in the battle of audio.
Except than your PCB it is very tidy (for anyone which don't know that, a tidy PCB it requires enough hours or enough days for her designing) and beautifull, it is also obvious his high quality of manufacture. I don't know in Denmark but in Greece, the PCB workshop owners are speculators and thus they accept orders from 100 pieces and above. If you request from them one or two or four samples, the most likely that you will hear it is "hey boy went to your house" and in the worst case "for one piece or for one hundred pieces you will pay the same amount". Thus i am in the difficult position to make the dirty work of PCB making in my home when they are of samples. Tell me your experience about this subject, in your country it happens the same?
Regards
Fotios

[Jan Dupont]

Hi fotios

Thanks for the kind words.....
And yes it takes many hours a days for many weeks to make a good looking layout But no problem here, as I just love making layouts.....

There will always be big difference in unit price ordering a few sample PCB's compare to ordering 100's or 1000's PCB's.

However I normally orders 10 to 25 pcs. and get some fair prices by allowing long delivery time... And then I sell or trade the PCB's I don't need. You may concider that solution

[fotios]

Originally posted by ACD
Hi fotios

Thanks for the kind words.....
And yes it takes many hours a days for many weeks to make a good looking layout But no problem here, as I just love making layouts.....

There will always be big difference in unit price ordering a few sample PCB's compare to ordering 100's or 1000's PCB's.

However I normally orders 10 to 25 pcs. and get some fair prices by allowing long delivery time... And then I sell or trade the PCB's I don't need. You may concider that solution

Hi again Jan
Thanks for reply. In order to I make a direct comparison in prices between Greece and Denmark workshops can you tell me for example the dimensions and the cost per piece (for 10 to 25 pcs order as you refer) of your double sided PCB presented in the photo?
Fotios

[Jan Dupont]

Prices per board (standard FR-4) are like follows:

10 pcs. €28,60 per board
25 pcs. €13.43 per board
Both allowing long deliver time....

Working on a supplier, that seems to make it 1/3 cheaper at 25 pcs.

[fotios]

Originally posted by ACD
Prices per board (standard FR-4) are like follows:

10 pcs. €28,60 per board
25 pcs. €13.43 per board
Both allowing long deliver time....

Working on a supplier, that seems to make it 1/3 cheaper at 25 pcs.

Thanks Jan for the informations. Indeed and in Denmark PCBs are expensive as in Greece
Fotios

[Jan Dupont]

Quality costs....
However not much fun to spend so many hours making the layout, and then make some c****** boards your self in the basement

Sorry for the low res in the attached picture