Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Solid State Talk all about solid state amplification.

C-Audio RA2000 Protection LED
C-Audio RA2000 Protection LED
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 6th November 2011, 11:22 PM   #31
tauro0221 is offline tauro0221  United States
diyAudio Member
Join Date: Nov 2008
Location: Victoria,TX
Normally the protection relay is to protect the speaker in case of one of the output transistors shorted or failed. This is because the speaker are connected directly to the output transistors. Suggestion power the amplifier and check the voltage before the speaker relay contact. If you read a neg/pos high voltage means that's ones of the output transistor it is leaking. If the voltage is high the relay will enable disconnecting the speakers. Sometime power transistors will check OKAY statically but when they are put under power they failed.
  Reply With Quote
Old 7th November 2011, 06:45 AM   #32
east electronics is offline east electronics  Greece
diyAudio Member
east electronics's Avatar
Join Date: Jan 2006
Location: Athens GREECE
there is an 1K resistor that goes open and if it does protection stays on for no other obvious reason .... been repairing this twice so far in RA 2000 but never though of writing down the part number ...

only i remember is that resistor is located on the rear area of the amp and if try to measure on board can confuse you

  Reply With Quote


C-Audio RA2000 Protection LEDHide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Audio protection circuit for microprocessor ADC? Neil_J Digital Source 1 26th June 2007 07:33 PM
over-temperature protection for audio smps zilog Power Supplies 5 19th January 2007 01:51 AM
Planet Audio PA4004 protection problem dre0011 Car Audio 7 20th November 2006 11:24 PM
troubleshooting pwr protection, car audio amp masterchief Solid State 11 10th September 2006 12:26 PM
Over-current protection in Audio IC Output Buffers ppl Solid State 1 21st October 2003 06:35 AM

New To Site? Need Help?

All times are GMT. The time now is 05:18 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.79%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio