differential design, common mode noise rejection

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Dear,

I'm busy with a real differential pre-amp design. In fact four amplifier stages. one plus and one minus per channel.

If I fed a real balanced signaal through those stages, the real common mode happen at the poweramplifier side and not in the pre-amp.

I want to have a common mode already at the input of my pre amplifer. So what to do. I don't want a opamp in the input that's makes the signal unbalanced to make it balanced later. So I was thinking about (for example) a Jensen input tranformer direct after the balanced input, direct followed by the amplifer stages.

Any thoughts?

Beste Regards,
Bas
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.