Join the Krell Klone group.
You might not be able to get to full 50w pure class-A but even 20 watt pure class-A with 100 watt class-AB will make a nice amp based on your Trafo's.
I have some original Klone PCB's for the MJL devices and Mark has the Pinkmouse PCB's with TO-3 metal cans, take your pick.
Join the thread.... Mark also has some extra PCB's available.
More info in the Wiki...see my signature.
You might not be able to get to full 50w pure class-A but even 20 watt pure class-A with 100 watt class-AB will make a nice amp based on your Trafo's.
I have some original Klone PCB's for the MJL devices and Mark has the Pinkmouse PCB's with TO-3 metal cans, take your pick.
Join the thread.... Mark also has some extra PCB's available.
More info in the Wiki...see my signature.
Hi,
2 * 35Vac will give about +-50Vdc PSU. With 280VA I suggest looking for 100W into 8ohm classAB amplifiers.
Your PSU will support a stereo amp of 100W+100W or a monoblock 200w into 4ohm.
If you really want to use up heatsinks then a high bias design might suit in which case a FET output stage as Borbely might be even better.
Good luck.
2 * 35Vac will give about +-50Vdc PSU. With 280VA I suggest looking for 100W into 8ohm classAB amplifiers.
Your PSU will support a stereo amp of 100W+100W or a monoblock 200w into 4ohm.
If you really want to use up heatsinks then a high bias design might suit in which case a FET output stage as Borbely might be even better.
Good luck.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.