|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|31st May 2005, 05:19 AM||#1|
Looking for guide for refurbishing SS amps
I have an old Muntz X-1000 amp with am/fm reciever, that kinda goes, but has several problems:
-power supply bottoms out at quite low level (that invlovel bass)
-channels seem to me mixed together (sounds kinda like mono, as both are playing the same stuff)
-adjusting any controls give out poping and cracking noises.
I woyuld like to refurbish this amp to fix the mentioned problems.
I looked around the net but i could not find any "refurbishing solid state amp guide" anywhere.
I'm not an electronic pro, but i know how to solder and use multimeter, and if I had a comprehensive guige on how to go about it, I'll definitely attempt to refurbish this amp.
Could anyone point me out to a good guide located on the internet or recommend a book that would get me started ?
thanks in advance.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Refurbishing Polk RTA 12||901Fixer||Multi-Way||1||14th July 2009 03:24 PM|
|Amp refurbishing question.....||69CamaroSS396||Tubes / Valves||14||23rd June 2009 11:06 PM|
|Idiotīs guide to building Pass amps?||judge||Pass Labs||3||19th December 2004 11:33 PM|
|Installing car amps and woofer....guide needed||fannie||Car Audio||0||12th March 2004 09:38 PM|
|Op Amps for Everyone Design Guide (Rev. B)||lohk||Solid State||2||14th July 2003 11:15 AM|
|New To Site?||Need Help?|