|11th January 2005, 01:55 PM||#21|
Join Date: Dec 2004
Location: TPA HQ (The Basement)
How about we step back to a sweet aluminum case with vertical dados every inch or soe around the perimeter. Then we can slide in dividers, heat sinks, and other do-dads with pc card mounts etc. Maybe a nice shielded box for your transformer/caps/bridge that will drop in and lock in the slots.
Could still have some kind of bus-bar system for power, but maybe instead of fixed rails, there are copper rails of varying lengths (and Gauge equivs) that are insulated except at the ends, that screw to the PS box and to the boards.
Sort of like those cheap little plastic project boxes, but not cheap, not plastic, and not little.
Could still have various sizes of the sides/backs/tops, but in common dimentions and with common dado spacing.
Still just throwing ideas.
Also, how about some face plates with some generic hole configurations to accomidate switches and leds. Or a face plate with a big square hole with swappable insert plates.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Open call for suggestions on Open Source DIY Audio Design||gfergy||Everything Else||1||15th April 2007 08:33 AM|
|chassis cad design||hcbonfim||Parts||0||29th November 2006 10:28 PM|
|Gutted amp on an open chassis...||EchoWars||Solid State||2||5th April 2005 04:34 AM|
|Generic Open Chassis Design ...||TVP||Class D||0||12th January 2005 04:21 PM|
|Generic "Open" Chassis Design Effort ...||TVP||Chip Amps||0||11th January 2005 05:08 AM|
|New To Site?||Need Help?|