diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   B&K ST 125.2 Modification Project (http://www.diyaudio.com/forums/solid-state/48669-b-k-st-125-2-modification-project.html)

spence 30th December 2004 02:07 PM

B&K ST 125.2 Modification Project
 
Hello All,

I have modified a B&K ST 125.2 power amp with the following:

1. 10 uF electrolytic input caps changed to Solen Fast Caps

2. Power supply capatance upgraded from 30,000 to 60,000 uF

3. Power supply caps bypassed with 10 uF and 10 nF caps as an RF filter in the PSU (to allow for the fact that really big caps may not have the HF response of smaller caps)

Anyway, my question is this:

On each channel PCB there are two N- and two P- MOSFETs for the output stage. However, on the PCB there are empty spaces which are labeled and have traces for additional MOSFETs (and sharing resistors). The heatsink that the MOSFETs are on are even pre-drilled for the open spaces in the board.

If would populate these empty spaces with the additional MOSFETS, this would double the number of output devices (which is why I would like to try this). My guess is that the next model up from my amp (the Reference 200.2 uses the same PCBs with a larger transformer and PSU).

Can anybody guess if this will work? Does anybody know if trying this could severly damage the amp?

Sorry that I have no schematics... B&K is not very forthcomming, and a web search found nothing.

I apreciate any comments.

Thanks in advance,

Spence


All times are GMT. The time now is 09:18 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2