Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Solid State Talk all about solid state amplification.

op-amps - phase response?
op-amps - phase response?
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Reply
 
Thread Tools Search this Thread
Old 1st July 2004, 10:47 PM   #1
Dominique is offline Dominique  France
diyAudio Member
 
Join Date: Jul 2004
Location: Berlin
Default op-amps - phase response?

Hi everyone,
I'm new to this place and I hope that my first question isn't too stupid for this forum so I will be excluded!
I read some stuff on op-amps, but couldn't find an answer to my problem...

While looking at a few OP-amp datasheets,
I was wondering about their phase characteristics...

In most datasheets you can find a diagram with "open-loop gain" and phase over frequency.
Together with a few other parameters (noise and thd as the most important), I used that as a criterium to filter out OP-amps with unwanted characteristics. Namely: in case a considerable shift of phase between 20Hz and 20kHz appeared I excluded them from my list of possible audio op-amps.

But in some datasheet I found such a diagram each for open-loop AND for closed loop, and the phase over frequency curve was pretty different for both cases, so I imagine that the whole phase characteristic would change with the gain? Could somebody explain this bevaviour in more or less simple words?

How do you guys see if an op-amp is good for audio from the specs? I guess that some of the higher GBW op-amps (gain x bandwidth) not definitely designed for audio would be fine too, but how can I distinguish them from those which aren't - phase-response wise - and at a given gain?

Cheers
Dominique
  Reply With Quote
Old 2nd July 2004, 01:08 AM   #2
SY is offline SY  United States
On Hiatus
 
SY's Avatar
 
Join Date: Oct 2002
Location: Chicagoland
op-amps - phase response?
My first suggestion is to read up on feedback and opamp theory in a good basic text like Horowitz and Hill's "The Art of Electronics." The mysteries of Bode plots will become much, much clearer.

To get to your specific question, in a minimum-phase device like an opamp, the phase response is intimately tied to the frequency response. In fact, it's basically the first derivative of the frequency response with respect to frequency. (derivative = rate of change) So in a region where the response is flat, the phase shift will be zero. In opamp open-loop plots, you see the effect of the dominant pole, that is, a deliberately induced low-pass rolloff. The reason this is built into the opamp is to stabilize it when the feedback loop is closed. And indeed, you'll notice that the closed-loop plots show a much flatter, wide-band frequency response and correspondingly, a low degree of phase shift through the passband.

As a passing comment, don't get too excited about fantastic bandwidths- high speed circuits are a pain to get stabilized and any audible benefits are highly debatable, to say the least.
__________________
"You tell me whar a man gits his corn pone, en I'll tell you what his 'pinions is."
  Reply With Quote
Old 2nd July 2004, 01:35 AM   #3
Dominique is offline Dominique  France
diyAudio Member
 
Join Date: Jul 2004
Location: Berlin
Quote:
My first suggestion is to read up on feedback and opamp theory in a good basic text like Horowitz and Hill's "The Art of Electronics." The mysteries of Bode plots will become much, much clearer.
that's what I already did. I probably am missing too much of the basics...

Quote:
To get to your specific question, in a minimum-phase device like an opamp, the phase response is intimately tied to the frequency response. In fact, it's basically the first derivative of the frequency response with respect to frequency.
Wow, that's great to know!
That helps me a lot!

Quote:
As a passing comment, don't get too excited about fantastic bandwidths- high speed circuits are a pain to get stabilized and any audible benefits are highly debatable, to say the least.
No, I won't! In fact, like in all applications a little surplus is soothing, but if I get e.g 5 or 10 times what I need, I fear that I have to pay that somehow somewhere else...
But that increases the choice of op-amps greatly... I'll look through the datasheets tomorrow

After all, I DID get a lilttle excited, but temporary excitement is the fate of the diy'er, I think!

Thanks a lot, SY
Dominique
  Reply With Quote
Old 2nd July 2004, 01:51 AM   #4
jcarr is offline jcarr  United States
diyAudio Member
 
Join Date: Jul 2002
Location: Tokyo, Japan
Dominique: Note that it is also possible to use two opamps in a composite circuit for improved phase response. James Wong of Analog Devices wrote an application note on this.

See:

http://www.diyaudio.com/forums/showt...807&highlight=

And if you can't find AN107, study the OP-271 data sheet, also from Analog Devices.

http://www.analog.com/UploadedFiles/...557OP271_a.pdf

Unlike SY, I like wide-bandwidth amplifier circuits, as they tend to give me a sound that subjectively I prefer. But it is true that they can be a pain to stabilize. See:

http://www.diyaudio.com/forums/showt...867#post205867

http://www.diyaudio.com/forums/showt...957#post205957

http://www.diyaudio.com/forums/showt...000#post206000

I definitely recommend low-pass input filters.

hth, jonathan carr
__________________
http://www.lyraconnoisseur.com/, http://www.lyraaudio.com
  Reply With Quote
Old 2nd July 2004, 06:27 AM   #5
peranders is offline peranders  Sweden
Electrons are yellow and more is better!
diyAudio Member
 
peranders's Avatar
 
Join Date: Apr 2002
Location: Göteborg, Sweden
op-amps - phase response?
Default Re: op-amps - phase response?

Quote:
Originally posted by Dominique
How do you guys see if an op-amp is good for audio from the specs? I guess that some of the higher GBW op-amps (gain x bandwidth) not definitely designed for audio would be fine too, but how can I distinguish them from those which aren't - phase-response wise - and at a given gain?
Most opamps with a speed over 10 V/us are more or less suitable for audio but in some cases you must look more carefully at the performance such as noise, current capability, speed, input bias currents etc.
__________________
/Per-Anders (my first name) or P-A as my friends call me
Group buy: SSR03 Super Regulator Power Supply. Sign up HERE 14 pcb's in interest so far.
  Reply With Quote
Old 2nd July 2004, 07:01 AM   #6
sreten is offline sreten  United Kingdom
R.I.P.
 
Join Date: Nov 2003
Location: Brighton UK
http://www.dself.dsl.pipex.com/ampins/webbop/opamp.htm

some useful info.

sreten.
  Reply With Quote
Old 2nd July 2004, 04:34 PM   #7
Dominique is offline Dominique  France
diyAudio Member
 
Join Date: Jul 2004
Location: Berlin
thank you all! Now that gives me SOME more things to read!
I'm very glad - the responses were more helpful than I dared to expect!

Best wishes!
Dominique
  Reply With Quote

Reply


op-amps - phase response?Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Phase response inquiry omni Multi-Way 30 7th August 2017 10:07 AM
Measuring Phase Response of Drivers Iain McNeill Multi-Way 35 15th October 2007 03:13 AM
Phase response and imaging / resolution Branwell Multi-Way 9 25th October 2004 01:00 PM
Doubts on Phase Response and Frequency Response dumrum Multi-Way 11 5th April 2004 10:39 AM


New To Site? Need Help?

All times are GMT. The time now is 10:21 PM.


Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.79%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio
Wiki