|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|7th June 2004, 12:59 AM||#1|
Join Date: Nov 2003
Location: Atlanta, GA
Alright, let me give you a little background on my future setup before posing the question...
Limited Budget Setup
Toshiba SD-3950 (modded) -> ART DI/O -> Preamp (for volume control) -> Woofer Amp (from rythmikaudio) + Mains amp (Sonic Impact 5066)
Alright, what I was originally planning to do was take the signal from the preamp and run it through the Subwoofer Amp's built-in line-level highpass filter, then run that signal to my Mains amp.
It occured to me that this was probably not the best solution and that it would probably be better to have two signals going from the preamp to the woofer amp and the mains amp separately (intead of "daisy chaining" everything together) and have a passive X-over for the mains instead of using the subwoofer's built-in one.
So... My question is:
First of all, would the second proposed setup even work?
And if so, are there any simple preamp designs that would allow for two sets of RCA, line-level outputs?
This will be my first "front end" project and I only know the basics of electronics so this will probably also serve as a good learning experience.
Bipole Transmission Line TangBand 871s
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|DIY Sub amp recommendations||espressogeek||Solid State||2||4th June 2009 10:31 PM|
|SET recommendations||ALF in AUS||Tubes / Valves||11||16th November 2006 11:29 PM|
|Relay Recommendations for preamp?||lgreen||Parts||11||7th June 2003 04:38 PM|
|1st amp (and preamp) kit recommendations ?||greg7||Solid State||1||20th April 2003 12:56 AM|
|New To Site?||Need Help?|