|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|26th February 2002, 07:53 PM||#1|
Join Date: May 2001
Lt1360 power output stage (auto bias)
Hi Have anybody tryed this application http://www.linear.com/pub/document.h...n&document=146
If so are there a pcb layout ? if not I make up one my self.
I think it sound like a easy way to make high power amp without
having to worry about matching and bias.
If any one have coments about this application.
question on the secound power slice
is the 2n3904 /2N3906 conected to the same point (-12.5v/12.5V)
and at -15 /15+ ?
Is it so that a solution with 2 powerslice(4 output mosfets) can not run a 4 ohm load?
Is it posible to drive more output in parallel .example one lt1166
drives to pairs of output mosfets for more current?
How maney volt does the supply have to sec 2x. XX ac. ??
It look like it will be very expensiv trafo and caps .
any advice is welcome jc.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fixed bias vs. auto bias||HFGuy||Tubes / Valves||30||14th October 2011 10:45 AM|
|Output stage optimal bias||hpl||Everything Else||2||4th February 2008 03:53 PM|
|How to set the bias of a FET output stage?||SpittinLLama||Solid State||20||19th March 2007 02:21 PM|
|Auto Bias?||lpd||Tubes / Valves||0||18th February 2007 04:33 AM|
|bias trouble in pnp output stage||Easyamp||Solid State||5||17th December 2003 07:36 PM|
|New To Site?||Need Help?|