|15th June 2001, 02:24 PM||#11|
Join Date: Jun 2001
Location: Flanders, Belgium
1) it could be possible that the noise is picked up at your connectors: in this case you can compare the "signal"-input with the ground of the connector (you can do this with a simple opamp)
2) I've had the same problem with a mixer: be sure that your power supply isn't placed in the neighbourhood of connectors or wires. If this is the case, you can also use a kind of COAX-cable to reduce the noise. It is always better to put the power supply in a grounded metal case.
3) If the noise still excist (after 1 and 2) and when it goes away after grounding the input, you can place a resistor (ex.: 10 Mohm) between the input and the ground.
When you use "jack-connectors" with a "build-in switch", you can ground the input automatically to the ground when you pull out the jack.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Need help picking drivers for a 3 way||Mike82||Multi-Way||9||2nd April 2009 01:39 AM|
|My amp is picking up noise ...||Mambo||Solid State||5||3rd February 2008 07:23 AM|
|Need help picking a mid..||PoorSound||Multi-Way||44||4th September 2007 07:57 PM|
|Picking a tweeter, think I've got it...||wigginjs||Multi-Way||11||14th October 2004 11:59 PM|
|Why am I picking up so much noise on my scope?||Bricolo||Everything Else||54||8th June 2004 05:20 AM|
|New To Site?||Need Help?|