Hi Mile!Yes you can do it by yourself, use ETD49 core N97 material, wind 4 turns with 1,5mm wire for 50V secundar, turn 2-3m kapton tape for isolation and 12 turns with 1mm wire for primar...
For a symmetrical +/-50v did you used 2x4 turns in opposite winding?
Hi Mile!
For a symmetrical +/-50v did you used 2x4 turns in opposite winding?
Yes 2x4 turns but not in opposite windig. Just 4 turns with double wire and connect first from one to the last of second coil for central tap (gnd).
Are we speaking about this smps?
Yes SPS1000
But what is this soft start aux.secondary?
24V DC fan for cooling
And onother for aux +/-15v.....many coils difficult winding...24V DC fan for cooling
I can't see any protection circuit.
First step is to identify the cost.If isn't near the commercial one, maybe i will give a try.
Is this a tested or a beta version?
Last edited:
here is a final version of APEX regulated PSU made fine tuned with transformer snubbers and the premium wago 256-402 connectors for the o/p. The layout is single sided and can be etched at home. Or can be produced at boardhouse as a 2 sided layout.
regards
Prasi
regards
Prasi
Attachments
Last edited:
And the final circuit to go with the PCB please.
Attachments
Good work Prasi!
Q1 and Q3 types swapped around ? but that should be obvious to any builder.
Good work Prasi!
Q1 and Q3 types swapped around ? but that should be obvious to any builder.
Thanks EssB,
Yes, a mistake in arrangement of labels. Its now corrected.
regards
Prasi
Attachments
- Home
- Amplifiers
- Solid State
- Retro Amp 50W Single Supply