|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|13th April 2013, 02:13 PM||#1|
Join Date: Dec 2006
NEED HELP FOR NAD C-320 INT. AMP
Hi there, i'm seeking help for my AMP.
The R-Channel of my NAD C 320 sounds not tight and a bit distorted.
I did the the following check:
1. Initial Adjustment:
A. Output OFF-SET VOLTAGE
For L- Channel : I can get 20mv and the VR21 can adjust easily.
For R- Channel : I got 0.5V and the VR11 could not be adjsuted, no respose at all.
B. Idling Current.
For L- Channel : I can get 8mv between the TP1 and TP2, i can adjust the VR22 easily.
For R-Channel : I could not adjsut the VR12, no response at all even you turn it clockwise or counter CW
I also noticed, the 1st time i turn it ON, the amp will automatically in protection mode. But after turn it OFF and ON again, the problem is gone, but the sound at R-Channel is not good as the L-Channel as explained above.
Please advice what could be the problem on this AMP.
Thank you very much.
Last edited by gynco; 14th April 2013 at 03:37 AM.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|NAD S300 int amp problem||hifienthusiast||Solid State||19||20th September 2012 03:44 PM|
|Help by finding the right KNOB'S for Nad 320 Amp.||shaby||Parts||1||7th February 2011 08:04 PM|
|NAD c-320||yomartinmendoza||Solid State||2||20th June 2008 02:41 AM|
|WTT Amp6 Int. Amp for cheap chinese tube Int. Amp||mrdon||Swap Meet||2||28th July 2006 11:03 AM|
|GC compared with NAD int. amp||TDWesty||Chip Amps||11||4th July 2005 03:49 AM|
|New To Site?||Need Help?|