diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Help with stereo audio of Phono in Pioneer A80 amp (http://www.diyaudio.com/forums/solid-state/226739-help-stereo-audio-phono-pioneer-a80-amp.html)

maupertius 31st December 2012 09:48 AM

Help with stereo audio of Phono in Pioneer A80 amp
 
Hi, I'm new in this forum and not an expert in amplifiers.

I've got a Pioneer A-80 connected to a phono device. I have realised that the sound in one of my channels (the R one) stops after a while. In order to restore it, I have to slightly move the connector on the back of the amp, but after a couple of minutes it will stop working again.
The thing I can't understand is that when I put my amp in mono mode everything works fine, so it's only when I use it in stereo mode that this problem shows up.

Any suggestion?

TANDBERGEREN 31st December 2012 10:38 AM

You probable have a loose solderjoint in the amp somewhere.
Most certain on the input-board, around that R-connector.

maupertius 31st December 2012 10:42 AM

Thank, I'll have a look at that


All times are GMT. The time now is 03:03 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2