PS Audio Elite components??

[bugeyed]

I am restoring a PS Audio Elite & have an issue. There are a couple of discrete components that are loose & I need to know where they came from. It is a 4.7 ohm 5 watt or so resistor connected at one end to a .1 mf (I think) cap. I suspect they go on the output, as the speaker terminals are missing. Were there 2 of these resistor/cap arrangements & how are they connected.
Any help would be appreciated. Schematic would be way over the top!!

Thanks,
kev

 

[kevinkr]

Post pictures, the values you mention do seem to point in the direction of an output zobel network, and yes there would have been one for each channel output. Do not run the amplifier without them..

 

[bugeyed]

Thanks for responding.
So, this series RC network would be in parallel with the speaker out? Meaning one end of the resistor would be connected to the + spkr lug & the other end to the cap & the other end of the cap connected to gnd? Sorry to sound so dense Can't get a picture right now, but it's just a resistor & cap tied together at one end & both the other ends loose.

Thanks,
kev