diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Help understandin Self's V-I limiting (http://www.diyaudio.com/forums/solid-state/21014-help-understandin-selfs-v-i-limiting.html)

sam9 2nd October 2003 05:37 AM

Help understandin Self's V-I limiting
 
If anyone is familiar with the section in D. Self's book on single V-I limiting I would like to pose a question. First I can follow the discussion up through the construction of the 4-ohm reactive line. Also I have run a simulation that convinces me that the single slope protection circuit functions as claimed.

Now here is where I get stumped: In reference to Figures 13.4 and 13.5 he writes that R3=15k determines the slope of protection Locus 1 (and R3=10k determines Locus 2). What I don't see is how these two loci are derived from the information presented. It seems like it should be simple as you only need two data (slope + an intercept or two intercepts).

Can anyone explain how this is done such that I could reproduce the figure as shown?

Alternatively if it derived by running a simulation, ehat is the simulation set up? Not the schematic, but what component values are varied and what is the result variable that is sought?

This will probably be very simple, but I the moment I don't see it.

mrfeedback 2nd October 2003 05:40 AM

What, Mikek hasn't replied yet ?.

Eric.

jam 2nd October 2003 07:10 AM

Eric,

I think he left the forum.

Regards,
Jam

peranders 2nd October 2003 12:45 PM

Just check if he has been online lately, which he has....


All times are GMT. The time now is 12:23 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2