|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Solid State Talk all about solid state amplification. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
11th December 2011, 02:55 PM
|
#1 |
|
diyAudio Member
Join Date: Jul 2010
|
Cyrus 2 No balance
I have a cyrus 2 where the balance control is not working anymore or working badly. There is no separation between the channels when I am turning the knob.
Can anyone point me in the direction of the faulty component? Could be the pot off course, but coudl it be a bad cap or a bad transistor as well? |
|
|
11th December 2011, 03:51 PM
|
#2 |
|
diyAudio Member
Join Date: Apr 2008
|
Hi 02dag,
Normally the centre (wiper) connection of a balance control is connected to signal ground. Perhaps the potentiometer is faulty, or the ground connection to the centre pin is open-circuit. Regards, currentflow |
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cyrus 3 / Cyrus III amp help | contax | Solid State | 12 | 23rd October 2010 01:53 AM |
| WTB Cyrus 1 or Cyrus 2 amplifier | monstertrucker | Swap Meet | 0 | 20th November 2008 01:04 AM |
| Where to get balance controls? | Glowbug | Solid State | 5 | 26th October 2006 08:06 AM |
| Quad balance | ginsner | Solid State | 4 | 16th August 2006 08:04 PM |
| Are Balance Controls Still Necessary? | runeight | Tubes / Valves | 32 | 2nd November 2003 10:47 PM |
| New To Site? | Need Help? |
