diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Cyrus 2 No balance (http://www.diyaudio.com/forums/solid-state/202292-cyrus-2-no-balance.html)

02dag 11th December 2011 03:55 PM

Cyrus 2 No balance
 
I have a cyrus 2 where the balance control is not working anymore or working badly. There is no separation between the channels when I am turning the knob.

Can anyone point me in the direction of the faulty component? Could be the pot off course, but coudl it be a bad cap or a bad transistor as well?

currentflow 11th December 2011 04:51 PM

Hi 02dag,

Normally the centre (wiper) connection of a balance control is connected to signal ground. Perhaps the potentiometer is faulty, or the ground connection to the centre pin is open-circuit.

Regards,
currentflow


All times are GMT. The time now is 08:40 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2