vintage pioneer ad-360 wiring instructions

[jayking]

hi,
i have one of these vintage amps and i am not sure of how to wire it correctly,
it has the speaker outputs which is straight forward, power inputs which is also straight forward but with the input cables for the speakers there is also a skinny red wire which i dont know where it is supposed to connect to?
can you help me on this please ?
your help would be most appreciated.

[ingenieus]

The input cables for the speakers? Huh?

The only skinny wire I can think of is the ground wire for the phono input.

A picture would help.

[jayking]

No phono connection on this amp,is early 80's before phono was introduced. Ha speaker wires for input and outputs. But along with the input speaker wires there is a also a skinny red wire.

[sakis]

ad360 is a car audio amplifier ..... so you are posting in the wrong forum

then again i expect you to know that this is a 12 volt amplifier ....

[sakis]

if so then it should be like that
red is switched 12 volt from engine
yellow is permanent 12V
black is ground

paired green /green white left input
paired grey /grey white right input ...

also a picture will help

[ingenieus]

A car amplifier? Now you tell me....

[sakis]

ha ha ha ...that was a good one !!!!!
did you conect this to mains ???

[sakis]

Originally Posted by jayking

No phono connection on this amp,is early 80's before phono was introduced. Ha speaker wires for input and outputs. But along with the input speaker wires there is a also a skinny red wire.

people are getting confused with that ... say better RCA conectors ....phono might make someone thing phono stage or phono input ...