Need some help (big pic warning)

[Skankadellic]

I'm trying to remove a preamp section from a old non-working westbury (unicord) amp... I'm not good at schematics and need some help with some identification...



The blue highlighted wire leads from the pre section to a pc mounted above a heatsink. if that helps
The red and yellow lead to the black tube shaped piece. The black part lead to the output and the transformer.

If it remove the highlighted wires what do I connect them to/ what would I lable them...


Here's the schematic in .pdf
http://www.geocities.com/skankadellic/WestburyM1000.pdf

If the pic doen't load here's the link to it
http://www.geocities.com/skankadellic/0n3.jpg

[li_gangyi]

I dun seem to be able to see the pics and the pdf...

[Skankadellic]

Ok Try these.

This one is the amp.
http://us.f1.yahoofs.com/users/aaa7b...z2wP_AFvPdrbFc


This one is the schematic.
http://us.f1.yahoofs.com/users/aaa7b...z2wP_ATKj5nK2A

[paulb]

Nope.
"The page cannot be displayed"

[li_gangyi]

I managed to get it...the schematic is a bit blur though...

[li_gangyi]

And since the amp is non-working...why do you want to remove the "pre"?? Do you want to use it else where or something??

[Skankadellic]

I tested the preamp section and it's ok but the power section is fried. I'm trying to install the pre section in another amp I'm fixing...