Hello all, here is my proposed layout for my Tube pre + SS dual mono amp hybrid
Imageshack - layout1o.jpg
(sorry for the link but I get a broken image when I use insert pic)
Each PCB has single grounding point.
Not pictured:
AC input paths to power switch and Xformers are omitted for simplicity
Isolated RCA in (+)(-) -> Volume Pot (+)(-) -> Preamp In (-)(+)
Only (+) outs from Pre would go into Ampx2
Only (+) outs from Ampx2 would go to Binding Post (+)
Binding Post (-) : Directly to star ground
This is my interpretation of a star grounding system. I'm putting it up here because I don't know if it is right! Thank You
Imageshack - layout1o.jpg
(sorry for the link but I get a broken image when I use insert pic)
Each PCB has single grounding point.
Not pictured:
AC input paths to power switch and Xformers are omitted for simplicity
Isolated RCA in (+)(-) -> Volume Pot (+)(-) -> Preamp In (-)(+)
Only (+) outs from Pre would go into Ampx2
Only (+) outs from Ampx2 would go to Binding Post (+)
Binding Post (-) : Directly to star ground
This is my interpretation of a star grounding system. I'm putting it up here because I don't know if it is right! Thank You