diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Are you ready to face strong emotions?.. Dx Blame MKII and the Supercharged release! (http://www.diyaudio.com/forums/solid-state/175341-you-ready-face-strong-emotions-dx-blame-mkii-supercharged-release.html)

destroyer X 14th October 2010 08:47 AM

Are you ready to face strong emotions?.. Dx Blame MKII and the Supercharged release!
 
Soon!

December, 24 will be the release date, despite Brazilians are putting pressure on me to make it earlier.

The philosophy is "not to mess with a team that is winning!".

Doctor Self Blameless design, a tweaked and sligthly modified version, is doing fine, without complains, no reason to change model, as this amplifiers transformed all amplifiers i did in loosers!...have beated all them!

Hundred Brazilians almost finished building... almost 47 percent already made their amplifiers.... they have appreciated since the first moment the amplifier was demonstrated in the Audio Festival...where the Blame ST was considered an excelent amplifier, the best match with the high end speaker used as the main one in that Rio Audio Festival...there was compared with more sophisticated and more expensive units, and have acquired hundreds of fans,

The amplifier was so well accepted by my people, that i could return to the Brazilian forum, the place i was banished two times (second time using fake) because i have pointed Uncle Charlie's Canon to some few, already smashed, fellow citizens.... the forum owner, someone that prefered to see the devil to see me in that forum once again, accepted me back and supported me, erasing my dark previous criminal history in that forum....also brazilians, the ones i have accused that could not hold a soldering iron because would burn themselves, holding them wrong way, have forgived me and are with me...all that because the amplifier quality, not because my dark brown eyes.

Dx Blame MKII is almost the same amplifier...the same Dx Blame ST...but has two output pairs and some resistances had modified values...the idea is to be used by the ones have difficult speaker loads..the amplifier is beeing tested to face 2.5 ohms output impedance...keeping the same supply voltage of 35 volts, but reinforced supply, using another transformer that will feed more watts..the amplifier will "pump out" more than 200 watts, and because of that, the supply should be 250 to 300 watts to each channel, also condensers must be increased in capacitance

Dx Blame Supercharted is also almost the same amplifier... the same Dx Blame ST... but has two output pairs and some resistances had modified values.... all small transistors and VAS and drivers where replaced by other units able to face higher voltages..the idea is to allow folks to use non efficient speakers, giving them some "reserve of power"..the unit is beeing tested to face 4 ohms..we gonna see if it will manage to face that in the long term... supply voltage was increased, power jumped to 100 watts minimum at 8 ohms, around 200 watts at 4 ohms.... supply condensers will be changed, increased in value too.

All them can use Dx supply, Nabuco Speaker Protector, Nabuco Insertion Delay (Surge protector) and all them will be served by the same board.... say... you will be able to assemble the Dx Blame ST, the Dx Blame MKII and the Dx Blame Supercharged using the same board.

Part values will be printed into the board's silk screen, unless are parts that will have different values because of different models.... these ones will have the old style silk screen, showing R1, R2, C4, C5 and so on.

Boards will be almost squared, using Greek's beauty ratio of 1 by 0.6, the Greek Partenon shape, and are beeing prepared by two brazilians... Mitchel (Nabuco) and Renatovsky (Renato Comerlatte)...also we gonna have, as tradition, the very good help from Alex mm, that is traditional preparing excelent layouts to the Dx Corporation....all layouts will be offered in this forum, to you to etch.

Group buys will be stimulated, people can use the board they want, also running a couple of wires, you can use the lovely boards from the German Group (Rudi and Metal) and you can also use Todd Johnson's pioneer boards...the one inspired all other Blame boards.

People can enter and subscribe to the Brazilian forum, and there, they can, because members, order whatever they want.

Mitchel (Nabuco) will also produce boards to offer in his home page.... i will stimulate group buy to be opened here is this same forum we are now....in the www.diyaudio.com

The amplifier continues unbeatable (my personnal subjective opinion)... reason why i will be offering it, here, the next 10 years long!... will stop the day i found one unit better, them will point you the better one.... and even this way will continue with the Blame....maybe pointed as the second best one.

Boards are beeing made.... torture tests are happening daily..... these amplifiers are one step up in quality at your home and are highly suggested folks.... you gonna feel strong emotions and God's presence in your heart while listening the unit....this is guaranteed, exception is if you have not ears and have not heart!.... this way cannot listen or feel:)

Uncle Charlie, Mitchel, Renato and Alex mm will be working for your pleasure..give yourself the chance to listen the best wide world amplifier ever made (my opinion)

regards,

Carlos

destroyer X 14th October 2010 08:53 AM

About these amplifiers, i am publishing pictures in the Dx Blame ST thread
 
where you can see builder's pictures...looks alike because 100 brazilians have ordered kits..including parts... transformers, and now they are starting an enclosure group buy and finishing the heatsinks group buy...pictures are not so different, because boards and parts are almost the same (group buy)

Tests are published too..... the basic scope inspections and some audio torture will be shown in videos uploaded to Youtube...the links will be posted too.

Notice videos are uploaded too.... we are working fellows... to be offer you a safe amplifier, a tested one... a guaranteed one.... a reliable one ...an aproved by users one..... they will be tortured ...if smoke, will happens at my home and not at your home!

YouTube - Notice!, the Blame MKII and the Supercharged
YouTube - Supercharged, low power basic scope inspection
YouTube - Supercharged, 10khz square wave - 228 watts RMS

regards,

Carlos

bernhix 14th October 2010 08:56 AM

Keep it going Carlos....

More power and more design.....

destroyer X 14th October 2010 09:06 AM

Hello Berhix...... i am very glad you came to see me!
 
I am a kind of idiot use to be smiling and laughing almost all time long..some dislike me, no problems about... they will like my amplifiers.

Yes, i can be bad too..also i have a Canon and i know how to bite people too....have only not to bother me and i will be peacefull for the ethernity.

Here you see my style...iam that kind of retarded...yes i am this way!

YouTube - Trololo Sing Along!

regards,

Carlos

A square 14th October 2010 09:54 AM

hello sir ...... keep going ...
best of luck ........

destroyer X 14th October 2010 12:28 PM

This helps Asquare...this stimulate us to go on!
 
thank you,

regards,

Carlos

destroyer X 14th October 2010 02:07 PM

I am working with the Dx Blame MKII
 
I am not satisfied because my supply...will try once again with other supplies in parallel.

YouTube - Blame MKII torture, and will continue soon

A here a recording using a Flac file...not very good because the digital camera audio recording quality:

http://www.youtube.com/watch?v=nrb-AqVNK1I

regards,

Carlos

evette 14th October 2010 02:33 PM

Mr. Carlos keep up the great work. I will always look forward tgo seeing your wonderful designs,,and of course the great sound they produce..Evette

destroyer X 14th October 2010 05:31 PM

Thank you dear Evette...i am glad you came to support me
 
Well, you are a very important Dx Corporation Member...so.... you are always very welcome.

regards,

Carlos

destroyer X 15th October 2010 09:37 PM

You can see folks....Mitchel is already working and we have a layout preview
 
2 Attachment(s)
this board will fit:

Dx Blame ES
Dx Blame ST
Dx Blame MKII
Dx Blame Supercharged

Boys!..this is a preview only..will be even better.... Mitchel is working on that..not ready yet.

regards,

Carlos


All times are GMT. The time now is 01:02 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2