|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Solid State Talk all about solid state amplification. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
11th October 2010, 10:19 AM
|
#1 |
|
diyAudio Member
Join Date: Feb 2008
Location: Savannah, GA
|
Carver amp pops on right channel
Hello all,
One of my Carver TFM-25 power amps has the following symptoms: When I power it up, the the right channel emits intermittent popping noises for a short while and then either plays OK until I shut it off or the protective circuitry trips and shuts the amp down. I recapped this amp last year and I can do basic checks with my little Radio Shack DVM but I have basically no electronics experience and I'm lost when it comes to troubleshooting a malfunction. I'm wondering if the problem is a cap shorting somewhere but I wouldn't know how to find it if that were in fact the problem. Does anyone have any advice on how and whether or not I could troubleshoot this amp with just a DMV? I don't know where to start. thanks, Charlie
__________________
http://jazzman-esl-page.blogspot.com/ |
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carver M-1.5t loud noise on one channel | hybridge | Solid State | 1 | 25th March 2010 12:09 AM |
| Carver M4.0t with weak channel | sjdemark | Solid State | 12 | 6th February 2010 07:35 PM |
| Carver av 405 5 channel amp | soulsheiksan | Swap Meet | 1 | 22nd September 2009 09:33 PM |
| FS: Carver M1.5T 600w rms 8 ohm/channel | Bent | Swap Meet | 0 | 3rd June 2008 02:49 PM |
| Carver have internal fuse to protect channel dead? | doggie750 | Solid State | 13 | 7th July 2005 02:25 AM |
| New To Site? | Need Help? |
