OK no problem .....
Regards Alex
Dear Alex, I see D7 wrong polarity on the PCB board in post # 1625
Regards,
Yassud
Sorry my mistake !!!! Corrected now
I wonder if a moderator can help you replace the file in that post or at least add a note in that post to refer to a corrected file. I spent a few hours trying to get the amp working properly and somehow I got it to play but not well enough so it ended up on a shelf. I have replaced the diode but didn't have time to test. I will get to it later today.
Blessings, Terry
Blessings, Terry
My sr200 copyright by apex, pcb design by me
An externally hosted image should be here but it was not working when we last tested it.
Hi all.
I'm trying to make psu of sr50
but It's my first time making amp
and there's something I need your help
1. i see two 2SC5200 in schematic
but there's only one in pcb
is this pcb wrong? or is this ok?
2. and.. what is that 2k2 resistor tie to MPSA42//MPSA92 ?
just simple resistor or something else?
i don't know what to buy..
3. my hometown use 220v AC,
what transformer i should buy?
is this ? ( 220v AC primary // 2x40v AC secondary )
4. right side of trans, 4 diode making diamond
and the number 35A/400V
what is this?
I'm trying to make psu of sr50
but It's my first time making amp
and there's something I need your help
1. i see two 2SC5200 in schematic
but there's only one in pcb
is this pcb wrong? or is this ok?
2. and.. what is that 2k2 resistor tie to MPSA42//MPSA92 ?
just simple resistor or something else?
i don't know what to buy..
3. my hometown use 220v AC,
what transformer i should buy?
is this ? ( 220v AC primary // 2x40v AC secondary )
4. right side of trans, 4 diode making diamond
and the number 35A/400V
what is this?
Attachments
