|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Solid State Talk all about solid state amplification. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
31st August 2010, 11:31 PM
|
#1 |
|
diyAudio Member
Join Date: May 2010
Location: Florida
|
Adcom GFA-555 MK II P/S cap position
I'm in a jam of sorts, I recived my new BCH 15k@100 v caps today for my 555 MKII . The problem is I always write down or draw a picture but today I did not. I have the caps installed like the older gfa555 and need to know if it;s correct before I fire it up This what I have:
Front Panel left side front right side front - + + - left side rear right side rear + - - + Rear heat sink so looking at the amp from the rear this is what I have. I am just not sure it is the same as the GFA 555 ver I as this is a GFA-555 MK II Thank's in advance |
|
|
1st September 2010, 06:00 AM
|
#2 |
|
diyAudio Member
Join Date: May 2010
Location: Florida
|
Well. Just followed the schematic and wired it right up.
Front of amp facing you; Left front left rear + - - + right front right rear + - - + This is only for the Adcom GFA-555 MKII |
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adcom GF 555 Mk II , oppinions ? | thermal runaway | Solid State | 1 | 11th May 2009 01:14 PM |
| Adcom GFA-555 II Manual | Funkenstein | Solid State | 0 | 30th April 2007 01:11 PM |
| Please Help with ADCOM GFA-555 II | tman | Solid State | 9 | 22nd December 2004 01:21 AM |
| Adcom GFA 555-II- Didn't like short on output :-( | Magura | Solid State | 3 | 17th November 2004 02:17 AM |
| mods for Adcom GFA 555 II | vad69 | Solid State | 2 | 27th June 2004 12:39 AM |
| New To Site? | Need Help? |
