Fixing a Marantz SR8000 (fried input)
I just bought a Marantz SR8000. I searched threads for the issue and had no luck.
The guy I bought it from said he had his laptop hooked up to it (laptop turned to full volume) all day long, and the receiver started smoking. I didn't even know this was possible; the laptop must have been turned up REALLY loud.
Essentially, now the receiver doesn't do anything. The display lights up partially (but stays that way--none of the buttons change anything).
I opened it up, and as seen in the pics, two caps and a resistor are fried on the front aux-in board. Here's where I need help: Is this the only problem? I'm going to replace them soon enough, but even so, if the board is bad, it doesn't explain why the rest of the receiver doesn't function. Normally the unit should function, just that the aux input wouldn't work, right?
To get an idea of where the board is located:
I am looking at the diagram and it appears there is a small transformer that keeps certain circuits alive when the power is off. It's possible that it's not getting the right signals to switch the unit on.
Be more specific as to the symptoms and perhaps we can walk through it.
Marantz america, inc.
440 medinah road
roselle, illinois 60172
phone : 630 - 307 - 3100
fax : 630 - 307 - 2687
I hope this works. Attached is the diagram, with that AUX board at the bottom.
The IC on there is just an ordinary 4558. You can find the burned parts.
I can't thank you enough. I'm deeply grateful for the info you've provided and am going to get this taken care of!:)
|All times are GMT. The time now is 08:54 PM.|
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
Copyright ©1999-2016 diyAudio