this I made a long time ago here are the files the coil you can put it separate
"edited" I found it with coil even better
Attachments
Last edited:
I would like to finish ax-14 today and WHERE I should check mV and what should be the value please?
I had it written down, but I lost the paper
hi some say 15mV some one said 10mV. on the 5W resistor. i make 13mV on 5watt resistors.
There is an error in the image the diode on the right is wrongI would like to finish ax-14 today and WHERE I should check mV and what should be the value please?
I had it written down, but I lost the paper
Images just for info:
I would like to finish ax-14 today and WHERE I should check mV and what should be the value please?
I had it written down, but I lost the paper
Images just for info:
i cant open the images. best to attach to the forum's attachment tool.
I am using a tool for attaching images
I upload an image and than I will add direct link to image.
I am using a tool for attaching images
I upload an image and than I will add direct link to image.
proper method...
How to attach images to your posts.
Just from listening to the one channel the sound is very tight and defined. A huge step up from my chip-amp builds. That is a good tip on cases. At first the prices didn't look too bad but once I size one big enough to also hold the transformer and power supply they get expensive fast.
Attachments
Last edited:
Hello my friends, hello APEX.
Please tell me about the APEX AX20P amplifier, when the power is turned on, the protection provides a delay of 3 ... 4 seconds, which is good, but when the power is turned off, a slap is heard in the speakers. tell me how to get rid of the slap in the speakers when the power is turned off. I am using not stabilized power supply with 20000uF capacitors per shoulder.
Please tell me about the APEX AX20P amplifier, when the power is turned on, the protection provides a delay of 3 ... 4 seconds, which is good, but when the power is turned off, a slap is heard in the speakers. tell me how to get rid of the slap in the speakers when the power is turned off. I am using not stabilized power supply with 20000uF capacitors per shoulder.
Last edited:
Greetings my friends. I finished assembling the headphone amplifier. I liked the sound, good power, no distortion. Tested with Pioneer headphones, 32R impedance.
Thanks to APEX for this project, thanks to AlexMM for the PCB layout.
I want to add that initially the board has a small error, there is no connection of two diodes with GND in the protection circuit, I have completed the missing jumper.