Is this correct Sir??
Regards
R24 and R25 must be connect to +/-MV, add BAV21 in paralel with 100pF on drivers and it can work.
Regards
Like this???R24 and R25 must be connect to +/-MV, add BAV21 in paralel with 100pF on drivers and it can work.
Regards
With only one mosfet on step driver,how much final transistor can be use???
Regards
Attachments
Like this???
With only one mosfet on step driver,how much final transistor can be use???
Regards
This is OK, 4 pairs is maximum with this topology, for more outputs you must add predrivers (triple darlington) and more step mosfets.
Regards
Ok..thank you Sir....This is OK, 4 pairs is maximum with this topology, for more outputs you must add predrivers (triple darlington) and more step mosfets.
Regards
Regards
sir mile,
if two mosfet should be use in 4 pair of output,how many mosfet in 6 pair,8 pair,how to determine step drive mosfets?
Use 2, 3 or 4 IRF540 mosfets, IRF2807 can be use for 4 outputs.
h900 with speaker protector
already on trial, and the results are okay
An externally hosted image should be here but it was not working when we last tested it.
Sir Plz send pcb layout pdf file
@ ravpreet420 pls be aware that this design have some error example look pin 5 of the ic ne5532
try to compare with this
try to compare with this
Attachments
Last edited:
Thanx irvynejayyes i did build it leach 700w but in 2 r witch is not good ,so far H900 is more clear and punchy to me
- Home
- Amplifiers
- Solid State
- 900W H-class PA Amp with Limiter