Hello:
I have a solid state power amplifier (B&K ST140) that has a
sort of filter on the output stage just before going to the
output posts. There is a 1200 ohm resistor in parallel with
a 0.1 uF film capacitor between the output and ground.
Can anyone tell me what this does? Does it roll off high
frequency response above a point?
Thanks!
fastcat
I have a solid state power amplifier (B&K ST140) that has a
sort of filter on the output stage just before going to the
output posts. There is a 1200 ohm resistor in parallel with
a 0.1 uF film capacitor between the output and ground.
Can anyone tell me what this does? Does it roll off high
frequency response above a point?
Thanks!
fastcat
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.