I bought the following chip from renton which is a preprogrammed PIC and works on sony protocol. I would like to use this for remote control of my preamp (volume up /down). The problem with the chip is that its output is not in pluse mode. ie. if I press the remote , the corresponding output goes from 0 to 1. It stays at 1 till I press the button again. Is there any circuit to drive relays momentarily ie it clicks everytime the output at PIC changes???? thanks
http://www.rentron.com/remote_control/IR-D14.htm
http://www.rentron.com/remote_control/IR-D14.htm
Many ways to skin a cat.
Edge triggered "one-shots".
Example; The cmos chip, the 4538 is a monostable multivibrator.
It's edge triggered, either rising or falling edge (you pick).
You select the output pulse duration. Connect the output
to a transistor to drive the relay.
http://www1.jaycar.com.au/images_uploaded/CD4538BC.PDF
Edge triggered "one-shots".
Example; The cmos chip, the 4538 is a monostable multivibrator.
It's edge triggered, either rising or falling edge (you pick).
You select the output pulse duration. Connect the output
to a transistor to drive the relay.
http://www1.jaycar.com.au/images_uploaded/CD4538BC.PDF
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Solid State
- Momentary relay driving circuit