|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|12th November 2008, 10:30 AM||#41|
Join Date: Feb 2004
Location: Recife - Brasil Northeast
No more Optimus.... adjusting bias, and comparing with the HRII
... i found that 1 ampere or higher standby bias does not give us any advantage into sound reproduction.... TESTED!
I found was sligthly mufled into higher bias....also i have found the optimized bias point is around 250 miliamperes (as Nordic said..he was rigth!).
Comparisons made, using two identical amplifiers, same parts and same supply, into a single speaker, gave me this result..instead to adjust your stand by bias to 60 to 100 miliamperes, it is better to increase it to 250 to 300 miliamperes because performance was better than lower bias and higher bias.
So.... Optimus is dead....now we have HRII Optimized!
Be happy folks.
Enjoy Dx Amplifier.... sounding near the perfection.
This Sunday assemble a toy amplifier....a good fun to your weekend; https://www.youtube.com/watch?v=yk0qvkwsAOY
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Found this -well prepared- TDA1562Q 70watt amp. schematic..||deepanger||Solid State||30||15th December 2010 04:23 AM|
|Grid bias with Class A SE ?||ThSpeakerDude88||Tubes / Valves||11||20th April 2008 05:01 PM|
|Inverting amp + Class A bias. is it possible or not?||Archwn||Chip Amps||6||1st August 2007 02:53 PM|
|Class G Bias Questions||Randy Knutson||Solid State||7||18th December 2004 02:28 PM|
|lm6172 class a bias?||crippledchicken||Parts||0||3rd September 2004 04:33 AM|
|New To Site?||Need Help?|