RCF DCA1050 in Parallel Mono

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
We have an RCF DCA1050 stereo power amp, they have a spec sheet rating of 2 x 500W into 4ohms, 2 x 310W into 8ohms. It also says Bridged mono: 1000W into 8ohms and Parallel Mono 1000W into 2ohms.

Does 'parallel mono' mean we can connect the L&R output terminals together to drive a mono load? There's a Parallel Mono slide switch at the rear but I think it just feeds the signal received by Ch1 into the preamp for Ch2.

Advice gratefully received!!

Thanks, Kev
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.