|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|27th August 2007, 10:31 PM||#1|
Join Date: Apr 2006
Blog Entries: 2
I recieved a Hafler DH101 pre in semi-working condition . It has a high noise floor (no hum, just noise) and sound does make it through the pre, but it is not fullrange and the vol control has to be turned fully clockwise to get anything.
I have the service manuel.
Now, i have +/- 18v from the power supply, so thats working. I checked to see if any of the tantalum caps had shorted and they okay. Should i go ahead and replace the tantalums and electrolytics in the circuit? With no voltage chart i'm at a loss at where to go from here.
Any suggestions? Thanks.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Hafler DH101 preamp repair and mods?||jarrettl||Solid State||117||22nd December 2014 02:07 AM|
|Hafler Preamplifiers - DH101 vs. 915||bcrescen||Solid State||6||14th July 2008 10:30 PM|
|Help troubleshooting Zen V4||ophilip||Pass Labs||18||11th February 2006 01:39 AM|
|help troubleshooting this diy pre-amp||zobsky||Tubes / Valves||21||3rd November 2003 12:06 AM|
|Troubleshooting||MikeBike||Solid State||3||30th September 2001 05:19 PM|
|New To Site?||Need Help?|