diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Krell KSA-150 will not turn on (http://www.diyaudio.com/forums/solid-state/102796-krell-ksa-150-will-not-turn.html)

Doral 30th May 2007 10:42 PM

Hello. I am looking for a schematic for a KSA-150. ANATECH : I see you have a schematic of the control board, but I cannot make out the components. Mine will not come on because it simply fries the 4 - 10ohm resistors immediately. Someone else has had their hands in this one, so I am not even sure the 110/220 switches are in the correct position. I tried to start a new post, but it will not let me since this has some of the same info.

anatech 31st May 2007 04:00 AM

Your new thread
 
Hi Doral,
Okay, I split this off for you. There was a small box on the upper right asking you to check it if you have already searched.

First, check your mains settings. I'm going to bet that you have a short somewhere in the power supply or amp sections. This would cause the surge relays to remain off and allow the resistors to burn. This is from memory because I can't find a diagram of the primary circuit at this moment.

-Chris


All times are GMT. The time now is 04:52 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2