Any thoughts on a speaker protector using a MOSFET.
Here is one I designed. Uses a SCR as a trip controller.
http://byrne.isa-geek.com/brendan/protector.bmp
Here is one I designed. Uses a SCR as a trip controller.
http://byrne.isa-geek.com/brendan/protector.bmp
I'm not the best with this kind of stuff, but I'll give it a shot.
The AC loss detect looks fine, but won't do anything if the SCR is limited by a 2.2M resistor (I don't beleive it will trigger), same goes with the DC detect.
The DC detect system doesn't make sense to me so I'll let someone else coment on it.
Theres no need for a 8 ohm resistor on the relay, why have one end of the speaker grounded and the other go through an 8 ohm resistor to ground, makes no sense to me.
P.S I re-did your schematic, I was having a hard time reading it.
The AC loss detect looks fine, but won't do anything if the SCR is limited by a 2.2M resistor (I don't beleive it will trigger), same goes with the DC detect.
The DC detect system doesn't make sense to me so I'll let someone else coment on it.
Theres no need for a 8 ohm resistor on the relay, why have one end of the speaker grounded and the other go through an 8 ohm resistor to ground, makes no sense to me.
P.S I re-did your schematic, I was having a hard time reading it.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.