diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Solid State (http://www.diyaudio.com/forums/solid-state/)
-   -   Impedence from Neutrik SpeakOn (http://www.diyaudio.com/forums/solid-state/100012-impedence-neutrik-speakon.html)

Nicholas1520 13th April 2007 08:36 PM

Impedence from Neutrik SpeakOn
 
If I were to use a 4 pin (2- 2+) Speakon connection right to a Behringer EP1500 for a subwooder which has 2 voice coils and it can be bridged to 8 ohms and drop to 2 ohms. But with leaving the configuration as 4 ohms on one coil and 4 ohms one the next coil will the amp give out 4 ohm power or will it give out 8 ohm power?

AndrewT 14th April 2007 04:16 PM

Hi,
does the Behringer ep1500 have two channels each capable of driving 4ohm reactive loads?

If yes, then connect one voice coil to one channel and connect the other voice coil to the second channel.

send an identical mono signal to both inputs and the amp will drive both coils together and give the speaker the total power that it can drive into two 4 ohm loads.

Forget about 2ohm as I suspect the amp can only drive 2r0 resistive loads and even then only for short term loading. The heatsinks will just get too hot. But it is nice to know that the semiconductors are designed to survive the currents when cold or cool that a 2r0 load demands.


All times are GMT. The time now is 09:18 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2