TINA Oscilloscope Problem

richie00boy · 28th September 2010, 12:20 PM

I'm using TINA-TI and it's all good apart from I can't get the oscilloscope to sync properly to the waveform and display it without scrolling along. On a real scope you adjust the trigger level to stop the wave scrolling left to right, but nothing I try with the TINA scope seems to make any difference. Anybody got any ideas or experienced this problem?

jgray · 9th November 2010, 02:52 AM

Under the trigger section, first set the mode to Normal instead of Auto. Then set the source to the signal you are interested in. You may want to use the little probe down towards the bottom to click on the circuit node of interest. Then you may have to hit the Run button again. Good luck!

Joel

richie00boy · 9th November 2010, 12:24 PM

Thanks, somehow not long after I was fiddling and managed to do this and forgot to update this thread. Thanks for confirming it.

28th September 2010, 12:20 PM	#1
richie00boy Did it Himself diyAudio Member Join Date: Nov 2003 Location: Gloucestershire, England, UK	TINA Oscilloscope Problem I'm using TINA-TI and it's all good apart from I can't get the oscilloscope to sync properly to the waveform and display it without scrolling along. On a real scope you adjust the trigger level to stop the wave scrolling left to right, but nothing I try with the TINA scope seems to make any difference. Anybody got any ideas or experienced this problem? __________________ www.readresearch.co.uk my website for UK diy audio people - designs, PCBs, kits and more

9th November 2010, 12:24 PM	#3
richie00boy Did it Himself diyAudio Member Join Date: Nov 2003 Location: Gloucestershire, England, UK	Thanks, somehow not long after I was fiddling and managed to do this and forgot to update this thread. Thanks for confirming it. __________________ www.readresearch.co.uk my website for UK diy audio people - designs, PCBs, kits and more

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TI Tina	ctardi	Chip Amps	5	17th January 2010 12:47 PM
Oscilloscope Channel 1 problem on BK Precision model 2120	albertho	Parts	1	20th October 2007 10:21 PM
A problem with my oscilloscope	gaetan8888	Equipment & Tools	1	13th August 2007 11:41 AM
TINA Slow?	richie00boy	Parts	17	18th March 2007 06:02 PM
Oscilloscope problem	Alien8	Parts	1	13th November 2005 08:47 AM

New To Site?	Need Help?
Register to Participate Search Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read


	Please consider donating to help us continue to serve you. Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving

9th November 2010, 02:52 AM	#2
jgray diyAudio Member Join Date: Sep 2010 Location: Chicago NW suburbs	Under the trigger section, first set the mode to Normal instead of Auto. Then set the source to the signal you are interested in. You may want to use the little probe down towards the bottom to click on the circuit node of interest. Then you may have to hit the Run button again. Good luck! Joel

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)