diyAudio Forums Archive > Top > Amplifiers > Chip Amps chip amps into 6 ohm load - Click HERE for Original Thread Bengali Hi, my speakers are rated 6ohms. for the LM3886, do I need to parallel two of them? or one should be fine. has anyone made a higher power chip amp? 100-200watts? thanks mateo88 One will lm3886 definitely be fine, but the rails need to be at a somewhat lower voltage than if you were using an 8 ohm speaker. As for the higher powered amps, search for BPA-200. Bridge-parallel amps can put 200 watts into a 4 ohm load easily.

Page generated in 0.0173020362854 seconds with 16 queries,
spending 0.00903344 doing MySQL queries and 0.00826859 doing PHP things.

Powered by: Search Engine Indexer and vBulletin
Copyright ©1999-2008 diyAudio.com