• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Built Salas Shunt Regs - DVB-Projekt PCBs

Status
Not open for further replies.
Jump to Latest
UV101

UV101

Member
Joined 2008
hifisounds.co.uk
#1
Built and tested - were used for a couple of months before I decided to try something else!!

Pos regs using IRFP9140 and 220uF 35v Rubycon ZA
Neg regs using IRFP240 and 220uF 35v Rubycon ZA
Standard 0.6w metal film resistors and 5w wirewound

2 x Positive boards set to +5v
1 x 3 way TDA1541 board set to +5v,-5v & -15v

Single rail positives cost approx £30 each to build and the 3 rail approx £85.

Looking for £100 plus postage at cost for the lot. (Postage to western Europe £9)

I'll include a TDA1541 DVB-Projekt PCB (MKI) unused if you take all 3 boards.


089.jpg


093.jpg


092.jpg


An externally hosted image should be here but it was not working when we last tested it.
 
Status
Not open for further replies.
Top Bottom