Hi,
Do you know if the OD3 150V Tube reg. are prone to be noisy?
I built up a Foreplay III clone and getting hum. I never use the OD3 before.
I measure +150VDC at the output of the OD3 so it's working.
Non regulated DC heater with 10,000uF cap, +5.95VDC. Heater voltage is low but not the cause of the hum.
Do you know if the OD3 150V Tube reg. are prone to be noisy?
I built up a Foreplay III clone and getting hum. I never use the OD3 before.
I measure +150VDC at the output of the OD3 so it's working.
Non regulated DC heater with 10,000uF cap, +5.95VDC. Heater voltage is low but not the cause of the hum.
One exception - if there is added capacitance across the regulator tube it can make a fine oscillator. Not saying this is the case, but one to watch out for.All gas regulators can be a bit noisy. Unlikely to cause hum.
As kevinkr has suggested, any circuit or info that you can provide would be helpful in diagnosis.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.