Salas low voltage shunt regulator (V 1.0 ) for DAC and more

[quanghao]

Originally Posted by kevinahcc20

Quanghao,

You mention above that the individual sections of the PCB can be separated. The board design looks pretty tight at the junctions...perhaps you can add a dashed line to indicate the cut line for separating? Do you have a BOM list?

Hi! thanks your advance!
Now im testing with Salas CCS v1.2 with Salas shunt V1.
When it have good the layout out, i can open it again!
Thanks!

[Salas]

I don't know what you are mixing but If you will issue a full V1.2 to the general plug n' play public it will be a support nightmare, brace yourself.

[quanghao]

Originally Posted by Salas

I don't know what you are mixing but If you will issue a full V1.2 to the general plug n' play public it will be a support nightmare, brace yourself.

No! i test about The V1.2 CCs with Bc560 and 2n5459, 2sk170
An shunt of V1.0 ( i like it)
If CCs V1.2 it work good with V1.0 Shunt, i can make it for diy!
What do you think it?
Thanks for advace!

[quanghao]

Hi ! Salas!
Now V1.0. it is very good at 3.3V, use MJE350 or Bd140!

[Salas]

Originally Posted by quanghao

No! i test about The V1.2 CCs with Bc560 and 2n5459, 2sk170
An shunt of V1.0 ( i like it)
If CCs V1.2 it work good with V1.0 Shunt, i can make it for diy!
What do you think it?
Thanks for advace!

Well, its a faster CCS, positive to have, should be no problem if it will work in your layout as a hybrid with a proven V1 shunt part. Make sure its absolutely stable on scope and for enough practical real life tests. VR1 1K will never take it to tens of Volt out. Also your 5459s will be dead at 40V you aspire. Designate a 5k trimmer and 28V max in 22V max out spec.

[Salas]

Originally Posted by quanghao

Hi ! Salas!
Now V1.0. it is very good at 3.3V, use MJE350 or Bd140!

I know, I have communicated such below 5V BJT solutions for TT DC motors and #26 filaments ages ago. MJE is 500mA max though, you better spec moderate loads and settings for such, before your customers will rev em up thinking they are like the Mosfets stuff.

[quanghao]

Salas!
you go to your topic: I post one image!
The simplistic Salas low voltage shunt regulator

[regal]

Quanghoa, Are you planning on offering negative shunt reg boards?

[quanghao]

Originally Posted by regal

Quanghoa, Are you planning on offering negative shunt reg boards?

Hi! Regal!
Yes! i will make it with GR !
Thanks

[Yomanze]

Hey Quanghao,

How about producing PCBs with one shunt per board, positive or negative? Anyone else think this is a good idea? Would buy 4x for an I/V stage.

Cheers,

Neil