Quick MTX Thunder 4250D question

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I just returned to life badly abused 4250D amp. Will this amp survive with IRF540's in place of SSP45N20A's as there isn't even close to 200V on rails? Gate resistors was completely burnt too, replaced them with 47Ohm. Divers survived, pre-drivers failed too. Playing for an hour... but still scary :eek:
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.