• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Amp Board Project for Parts

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
speaker

speaker

Member
Joined 2004
This was a 150W/4-ohm amplifier design. I cannot remember though how I came buy it and all the doc's I had with it are MIA too. I have never attempted to get it going so I do not know if it works. I am selling it for parts or the intrepid resurrector. The main points of interest are as follows:

2x 10,000uf / 50V / 85C / TSU-type main filter caps
1x MPIL40 bridge rectifier (large)
1x KBP02m bridge rectifier (small)
1x LM337T
1x LM317
1x TL072CP 8P op-amp (legit TI fab)
2x Sanken 2SC3519A NPN epitaxial planar transistor
Sanken 2SC3519A
2x Sanken 2SA1386A PNP epitaxial planar transistor
2SA1386A
Many other small parts, sand resistors, PCB fuse holder, misc. transistors (1239, 3068 dual packs)

$20/OBO



An externally hosted image should be here but it was not working when we last tested it.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom