http://www.flickr.com/photos/mr_ross/sets/716026/
Its not the worlds smallest, but those chips won't get hot. I know I went completely overkill on the chassis but I like it. I have a 650 VA torroid to slide into her and later on down the line i plan on designing a pair of monitors that will be actively crossed which will be housed i side the chassis so i will need some of the space.
Oh and I am using Brian's PCB and kits.
Its not the worlds smallest, but those chips won't get hot. I know I went completely overkill on the chassis but I like it. I have a 650 VA torroid to slide into her and later on down the line i plan on designing a pair of monitors that will be actively crossed which will be housed i side the chassis so i will need some of the space.
Oh and I am using Brian's PCB and kits.
Looks good...
I guess that you didn't see the U shaped aluminium sections in the same area..? Would have increased the finned area some-what.
Just remember to use heatsink compound under each fin, very sparingly, and youll be set for a multiple parallel chip output (or a bridgeclone, or an X-clone or,or,or Damn, too many choices)
Have fun
Owen
I guess that you didn't see the U shaped aluminium sections in the same area..? Would have increased the finned area some-what.
Just remember to use heatsink compound under each fin, very sparingly, and youll be set for a multiple parallel chip output (or a bridgeclone, or an X-clone or,or,or Damn, too many choices)
Have fun
Owen
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.