Dear all,
I have an intergrated amp, named Marantz PM-80a MOSfet (Not PM-80)and building a pre - tube amp. So I wanna use PM80a as a power only, means cut off pre-amp section of PM80a then connect directly from pre-tube amp to her power section. So, I will have a hybrid system.
PLS, advise me where will I do connect on board, or provide me schematic. Cause I am just a newbie, so could you give me some specific guide.
Thanks,
Cominup
I have an intergrated amp, named Marantz PM-80a MOSfet (Not PM-80)and building a pre - tube amp. So I wanna use PM80a as a power only, means cut off pre-amp section of PM80a then connect directly from pre-tube amp to her power section. So, I will have a hybrid system.
PLS, advise me where will I do connect on board, or provide me schematic. Cause I am just a newbie, so could you give me some specific guide.
Thanks,
Cominup
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.