250Volt N-channel mosfets for class d

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
in full bridge output stage, can I use 200V mosfet while I supply the full bridge stage with 260V?

As they are connected in serial, so the 260V is actually at both Fets?

You must be joking. Yes, you can connect 260 V - as long as amp is not operating. Do you understand what switch mode is? ... Try to think about the very very basics of ClassD amps!
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.