My ambition is to make a small power amplifier 10-20 watt.
It should be an A/B construction.
I have searched a lot on the internett and found a lot of schematics, but I not know what to look for, how a smart design looks like.
So to not start on a bad project I come to you for advice.
I would like to start on a project (schematic) which has been done before with great success.
My knowledge: I am study natural science and have had subjects as measurment and instrumentation. When that have been said my knowledge if electronics is low.
I have a opportunity to make PCB at my university.electronicsart
I will also need help to pick out parts as Toroidal transformers, Rectifiers, Capacitors etc...
Thanks for any advice!
It should be an A/B construction.
I have searched a lot on the internett and found a lot of schematics, but I not know what to look for, how a smart design looks like.
So to not start on a bad project I come to you for advice.
I would like to start on a project (schematic) which has been done before with great success.
My knowledge: I am study natural science and have had subjects as measurment and instrumentation. When that have been said my knowledge if electronics is low.
I have a opportunity to make PCB at my university.electronicsart
I will also need help to pick out parts as Toroidal transformers, Rectifiers, Capacitors etc...
Thanks for any advice!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.