Hi guys,
I have a mixer, compressor, motu, & an adat all plugged into a power conditioner.
Is there any reason not to leave all of my components on and just turn the power conditioner on & off?
The part of my brain that's fears the unknown says I might short something out. But the part of my brain that likes math says a switch is a switch so turning the power conditioner on & off should be the same as turning the components on & off.
Thanks in advance for the advice!
Mike
I have a mixer, compressor, motu, & an adat all plugged into a power conditioner.
Is there any reason not to leave all of my components on and just turn the power conditioner on & off?
The part of my brain that's fears the unknown says I might short something out. But the part of my brain that likes math says a switch is a switch so turning the power conditioner on & off should be the same as turning the components on & off.
Thanks in advance for the advice!
Mike
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.