Dear all friends,
I buy a Clone ProAC 1SC from China, I will not use the provided crossover due to poor components using.
I will re-design and make the Crossover using better components.
The question is, can I using the banana socket screw and nut directly mounting to the crossover?
i.e. No use additional input wire, using the banana as terminal to PCB.
Please comment.
Thanks
nFORCE.
I buy a Clone ProAC 1SC from China, I will not use the provided crossover due to poor components using.
I will re-design and make the Crossover using better components.
The question is, can I using the banana socket screw and nut directly mounting to the crossover?
i.e. No use additional input wire, using the banana as terminal to PCB.
Please comment.
Thanks
nFORCE.